10
Problem Possible cause Solution
No steam comes out of
the soleplate, the light of
the CALC CLEAN button
ashes and the appliance
beeps.
You have not done or have
not completed the Calc-Clean
process.
Perform the Calc-Clean process to enable
the steam function again (see chapter
‘Cleaning and maintenance’).
The appliance has
switched o.
The auto shut-o function is
activated automatically. The
appliance enters the standby
mode if has not been used for
5 minutes and swiches o if it
has not been used for another
10minutes.
To activate the appliance again, press the
on/o button. The appliance starts to heat
up again.
The appliance produces a
loud pumping sound.
The water tank is empty. Fill the water tank with water and press
the steam trigger until the pumping sound
becomes softer and steam comes out of
the soleplate.
Water droplets come out
of the soleplate.
After the Calc-Clean process
remaining water may drip out
of the soleplate.
Wipe the soleplate dry with a piece of
cloth. If the Calc-Clean light still ashes and
the appliance still beeps, perform the Calc-
Clean process (see chapter ‘Cleaning and
maintenance’).
You have used the steam boost
function too frequently.
Use the steam boost function only for
stubborn creases. It is recommended not
to use it for more than 5 times within 3
minutes.
The Calc-Clean process has not
been completed.
You have to perform the Calc-Clean
process again (see chapter ‘Cleaning and
maintenance’).
Steam condenses into water in
the hose when you use steam
for the rst time or have not
used it for a long time.
This is normal. Hold the iron away from the
garment and press the steam trigger.Wait
until steam instead of water comes out of
the soleplate.
Dirty water and impurities
come out of the soleplate.
Impurities or chemicals present
in the water have deposited
in the steam vents and/or
soleplate.
Perform the Calc-Clean process regularly
(see chapter ‘Cleaning and maintenance’).
Steam condenses into water in
the hose when you use steam
for the rst time or have not
used it for a long time.
This is normal. Hold the iron away from the
garment and press the steam trigger.Wait
until steam instead of water comes out of
the soleplate.
Water ushes out of the
soleplate.
You have accidentally started
the Calc-Clean process
(see chapter 'Cleaning and
maintenance').
Switch o the appliance. Then switch it
back on again. Let the iron heat up until
the ‘iron ready’ light lights up steadily.
The Calc-Clean process
does not start.
You have not pressed the CALC-
CLEAN button for 2 seconds
until the appliance started
beeping.
See chapter ‘Cleaning and maintenance’.
English
הצטרפו לשיחה על המוצר
כאן תוכל לשתף את מה שאתם חושבים על הPhilips GC6819 מגהץ. אם יש לכם שאלה, תחילה קראו בעיון את המדריך. ניתן לבקש מדריך באמצעות טופס יצירת הקשר שלנו.